Wiring Needed To Use Rampage Light Strip On 2012 Toyota Tundra

Published 12/04/2019

Products Featured in This Question

Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn - 4-Pole Flat - 60" Long

(75)

$99.49

Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Pole Flat Connectors

(763)

$36.46

Question:

what curt T connector do I need to hook up the rampage light strip on my 2012 Tundra

asked by: David G

Expert Reply:

The Rampage SuperBrite LED Tailgate Light Bar part # RA960134 does connect to a 4-pole flat trailer connector on the Tundra. For that I recommend Curt T-Connector Vehicle Wiring Harness for Factory Tow Package part # C55774 which will allow you to plug into the factory tow port under the bumper and gives you a 7-way plug and a 4-pole flat to plug your light strip part # RA960134 into. You can use both the 4-pole and 7-way functions at the same time as long as you don't overload the circuit which I don't see happening with the LED light bar because LEDs draw very little power. I have attached a photo of what your factory tow port under the bumper should look like.

If your Tundra happens to not have the factory 7-way tow package you can use Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # HM11141835 to power the light strip. This will plug into a square connector under the bumper.

expert reply by: Heather A