Is There a Way to Direct Wire Furrion Observation System Monitor to Vehicle Battery
Updated 06/11/2024 | Published 11/13/2019
Products Featured in This Question
Question:
Do you have a cable for the furrion monitor that I can wire directly instead of having to use the cigarette lighter?
asked by: Adam E
0
Expert Reply:
What you could do is cut the cigarette lighter plug off of the # C-FOS07TAPK-006 and then run the two wires directly to the vehicle battery and you will have made a way to wire the monitor directly. Most likely the wire would not be long enough so you'd need to extend that with wire you have currently or with 16 gauge wire like part # 16-1-1 which is sold by the foot.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Furrion Monitor Power Cable
- Accessories and Parts
- RV Camera System
- Cables and Cords
- Power Cord
- Furrion
more information >
Continue Researching
- Shop: Brake Controller
- Search Results: redarc
- Search Results: rear
- Search Results: redarc mounting panel
- Video: How to Install: K-Source Universal Towing Mirror on your 2020 Ford Ranger
- Search Results: redarc trailer brake controller
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Search Results: static/images/styles/checksvg
- Shop: K-Source Universal Towing Mirrors - Clip On - Convex Mirror - Qty 2
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Video: How to Set Up Your CIPA Universal Fit Towing Mirror on a 2020 Ford Ranger
- Q&A: What are the Torque Specs for the Buyer's Products Bolt-On 2-1/2" Hitch Receiver Tube?
- Shop: Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob
- Search Results: coleman ac
- Search Results: chill cube ducted
- Q&A: How To Power A Furrion Vision S RV Camera Monitor In A Vehicle Without A Cigarette Lighter Port
- Video: Redarc Tow-Pro Wiring Adapter for Tekonsha Brake Controller Harness Review
- Video: A Closer Look at the Redarc Tow-Pro Wiring Adapter for Tekonsha Brake Controller Harness
- Shop: 12 Volt Outlet Kit, 20 amps
- Shop: CIPA Universal Fit Towing Mirrors - Clip-On - Qty 2
- Video: In-Depth Review of the Buyer's Products Bolt-On 2-1/2" Hitch Receiver Tube
- Video: Review of Redarc Brake Controller - 331-TPSI-007
- Video: Feature Breakdown: Voyager Rear Camera with LED Low Light Assist
- Q&A: Could Cameras of Furrion Vision S Camera System be Active All the Time
- Q&A: How To Wire In A Power Source For The Furrion Vision S RV Camera System
- Q&A: Replacement Monitor Power Cord For A Furrion Vision S RV Camera System
- Q&A: Recommended TorkLift Tie Downs for a 2024 F-350 w/a 8' Bed and Factory Hitch
- Q&A: Replacement Monitor Power Cord for Furrion FOS05TASF
- Article: Types of Trailer Hitches: How and Why to Use Each
Explore Expert Info
![Our Expert]()
on Accessories and Parts
on Accessories and Parts
Jim V.
6/7/2024
Jameson, I was wondering the same thing but I want to clarify something to make sure, is there anything in the “cigarette lighter” power connector that in anyway changes the power supply from 12v to say 6v or anything or is it a straight 12v pass through? I am wanting to direct wire the monitor into one of my auxiliary switches.