How To Find the Correct Landing Gear Legs for a 2012 Keystone Avalanche
Updated 11/11/2019 | Published 11/10/2019
Products Featured in This Question
Question:
replacement landing gear recommendation for a 2012 keystone avalanche 5th wheel
asked by: Ken O
Expert Reply:
In order to find the correct replacement landing gear legs for a fifth wheel trailer I would need you to take two quick measurements of your existing landing gear legs, the outer tube length and weld stop spacing. I have attached a photo to assist.
The most common replacement landing gear legs are the Replacement 5th Wheel RV Landing Gear Legs part # LC179013 for lead and part # LC179014 for follow. These measure 29-1/2" on the outer tube and 15-1/2" between the weld stops (inside to inside).
Product Page this Question was Asked From
Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: What Replacement Lead Leg Do I Need for My 2011 Keystone Montana Trailer?
- Q&A: Replacement Landing Gear Legs Needed for a 2004 Arctic Fox 29.5E 5th Wheel Trailer
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Q&A: Replacement Landing Gear for 1995 Jayco Designer Series
- Q&A: Recommended Replacement Landing Jack System for 2008 Keystone Montana Mountaineer 345DBQ
- Q&A: Do Lippert Landing Gear Legs # LC179013 and # LC179014 Have Grease Fttings
- Article: Can I Put Wallpaper in My RV?
- Article: Best Landing Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: RV Winterization Guide: Step-by-Step Process from the Pros
- Article: Holiday 2025 | Best Gifts for RVing