What Hardware Is Needed to Mount Wheel to Redline Spare Tire Carrier # 413200
Published 11/05/2019
Question:
The last comment in the information on the 413200 says Hardware to attach wheel to carrier is not included. What additional hardware is required? If I purchase it I will be installing it on a 16 foot Big Tex utility trailer with 15inch wheels and and a 5 on 5 lug pattern.
asked by: Bob V
0
Expert Reply:
The recommended hardware to use with the Spare Tire Carrier # 413200 is 1/2 inch diameter nuts and bolts long enough to fit through the back of the mounting plate and through the wheel flange.
This would easily work to carry a 15 inch wheel that has a 5 on 5 inch bolt pattern too.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Spare Tire Carrier - Horse Trailer
- Spare Tire Mount
- Gooseneck Mount
- Weld-On
- 5-Bolt
- 6-Bolt
- 8-Bolt
- Trailer
- Standard Finish
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Swivel Jack w/a Wheel for a Boat Trailer
- Q&A: Erickson ATV E Track Tie-Downs For ATV With Backing Plates
- Q&A: Is There A Good Quality Aluminum Jack For Boat Trailer That Has Swivel Jack On Side Of Frame?
- Q&A: What Is The Difference Between Kenda AM10234 And KE88KV Tires?
- Q&A: Do These Kendra Tires with Americana Wheels Come with Center Caps or Lug Nuts
- Q&A: Options For Mounting A Spare Tire Under The Tongue Of A Trailer
- Q&A: Do I Have To use All Bolt Holes of E-Track ATV Tie Down Kit
- Article: Finding the Right Electric Winch
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 4 Common Myths About RV Solar Power
- Article: Dealer Spotlight - Croft Trailer and Hitches