Longest CE Smith Carpeted Bunk Boards and Are They Pressure Treated  

I've had to do this before, so I understand your concern about the carpet getting shredded. What I did was take a sharp utility knife and cut a small X right where I wanted to drill my holes. This worked very well and didn't rip up the…

Yes, based on the picture you sent in the CE Smith Bolster and Swivel Bracket Assembly #CE10000G that you referenced will fit and work well on your 1988 Landau Trailer.

The mounting bracket of the CE Smith Bolster and Swivel Mounting Brackets, #CE10000G-4, are bent at a 90 degree angle. The photo of the 4 brackets can be somewhat deceiving, but I grabbed one from our warehouse and made a short video for you so you…

Roller bunk brackets like the CE Smith Bolster and Swivel Mounting Brackets for Bunk Boards #CE10000G-4 do not have listed capacities. I spoke to my contact at CE Smith and he informed that that as long as you are under the capacity for your trailer…

The carpeted bunk boards, #CE27840, come without any holes drilled so you would need to drill to attach brackets and/or directly to the trailer. The reason they are not pre-drilled is because different trailers have different mounting location…

The problem is that your bunks need to face a different direction than what standard boat trailers have so it's hard to have a solution since your setup is unique. That said I don't see why you couldn't use CE Smith Bolster and Swivel…

It's not an exact science but typically you want the bunk boards on a trailer to extend all the way to the rear of the boat. It wouldn't hurt to have them go a bit beyond this too to ensure proper support during travel. Since the front of the…

You certainly could make your own bunk boards using pressure treated lumber and bunk carpet like #CE11372 if you wish. CE Smith doesn't use pressure treated lumber in their bunk boards because some of the chemicals used to pressure treat the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…