How to Wire Third Brake Light on Truck Cap Camper Shell Using 7-Pole
Updated 09/10/2019 | Published 09/08/2019
Products Featured in This Question
Question:
How to wire brake light on cap useing plugin 7 pole
asked by: Ray
Expert Reply:
The easiest way to use your vehicle's 7-way trailer connector to power up the third brake light on your truck cap is to first locate the right and left turn signal wires behind your 7-way.
Then simply tap into those and install the Pacer Performance 3rd Brake Light Logic Module # PP20-702 using the two yellow wires. Finally, run the green wire to the third brake light on your camper shell. Using the Logic Module will keep the third brake light from flashing when you apply your turn signals as it will filter out the signal much like an old school converter.
Since you'll be tapping into your turn signals at the back of your truck, you'll need some extra wire like part # 12-1-1 (per foot). To make the connections I recommend our Deka Heat Shrink Butt Connector (5-pack) part # DW05745-5.
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Search Results: cable jacks
- Search Results: spring loaded turnbuckles
- Shop: 3rd Brake Light Logic Module
- Shop: Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2
- Video: Complete Breakdown of the 3rd Brake Light Logic Module
- Shop: Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Shop: Brophy Heavy Duty Cable Camper Jacks - 57" Max Lift Height - 4,000 lbs - Qty 2
- Shop: Brophy Cable Camper Jack - 67" Max Lift Height - 1,500 lbs - Qty 1
- Shop: Brophy Cable Camper Jacks - 57" Max Lift Height - 3,000 lbs - Qty 2
- Q&A: Can Brophy Cable Camper Jacks Work if Camper Only Extends Out 1 inch
- Q&A: Are The Brophy Cable Camper Jacks Stable
- Q&A: Can The Brophy Camper Cable Jacks # CJ31 Be Used For Lifting A Camper Shell?
- Video: The Low-Down on the Brophy Cable Camper Jacks
- Q&A: Do Torklift Camper Tie Downs Require Using Spring Loaded Tie Downs
- Q&A: Does Smart LED Light Strip Require White Control Box To Change Colors With Remote
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Search Results: electrical grease
- Shop: TorkLift Basic SpringLoad Turnbuckles for Camper Tie-Downs - Qty 2
- Search Results: dexter 010~019~00
- Video: The Low-Down on the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package-C55384
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Backup Camera for 2016 Toyota Tundra with Slide-In Camper
- Search Results: truck camper stand
- Search Results: hitch extender
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2019 Chevrolet Colorado
- Shop: Suspension Enhancement
- Shop: Vehicle Tow Bar Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Custom Fit Vehicle Wiring
