How Many Terminals Are On the JR Products RV Landing Gear Switch
Updated 08/06/2019 | Published 08/04/2019
Products Featured in This Question
Question:
Does this have a 6 prongs for wires?
asked by: Jason
Expert Reply:
The JR Products RV Landing Gear Switch part # 37213635 has four terminals; power, ground, motor in, and motor out. This will be the case for all of our landing gear switches. That said, most likely you have dual landing gear motors and just need to combine the motor in and motor out for each side before attaching to the switch. If you like, you could also just use two switches, one for each jack leg. The Lippert Components 5th Wheel RV Landing Gear Switch part # LC145236 comes with the pigtail which will make the above process easier.
Product Page this Question was Asked From
RV Landing Gear Switch - 12V - Black
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- JR Products
more information >
Continue Researching
- Q&A: How Should the Power Mountain Tall Boy Jack Be Used If You have Torsion Axles?
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: How To Install The Start Capacitor On Advent AC # ACDOM150
- Q&A: What is the Holes Spacing for the RV Designer Baggage Door Catches?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Best RV Roof Vents
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Rooftop Cargo Carriers
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision