Mounting Bracket Dimensions of Manual Pull-Out Step

Question

Question:

What is the mounting bolt pattern? I need 14 x 7. thanks you.

asked by: Christy

0

Expert Reply:

The Manual Pull-Out Step for RVs - Double # LC432682 has mounting holes that are about 24" x 7" and although there are not any with a 14" x 7" pattern, you can still use this step. In order to do so you have a couple of choices. The first would be to weld the steps onto your RV while the other option would be to use Lippert Outriggers for Manual RV Steps # LC301704. You would need Mounting Hardware # LC118155-72 to attach the steps to the Outriggers.

expert reply by: Kyle S

0

Answer 1

Yes, you can absolutely use the Prest-O-Fit Wraparound Exterior RV Step Rug #PR22FR with your TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear #TLA8102. These wraparound exterior rugs fit straight steps that measure 20" wide and…

view full answer...

Answer 2

The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 4 Steps - 27-1/2" Base - 375 lbs #TLA8004 are a fit for your 2018 Grand Design Momentum 328M. They can be used to replace your current steps if desired. If you have factory…

view full answer...

Answer 3

There are 3 step pull out kits similar to the #LC432682 that you referenced but they are wider across the board so the exact mounting hardware you are using now won't work. The part #LC432690 would be a great solution for what you have but…

view full answer...

Answer 4

I attached a picture that shows the install holes for the Outriggers part #LC301704. There are holes on both ends of the brackets for the steps and for attaching them to your RV. The #SM-01 would match up to the install holes of the Flexco Manual…

view full answer...

Answer 5

We don't have an install picture but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of…

view full answer...

Answer 6

We have outriggers like the part #LC301704 which make installing pull out steps like the Lippert Steps part #LC432682 much easier. Your appear to be broken at the weld. The #LC301704 installs with included hardware.

view full answer...

Answer 7

I do have a solution for you, but the closest thing that we have to what you are describing is the SolidStep Manual Fold-Down Steps #LC698799. This would be compatible with your door width but is only compatible with a threshold range of 27" -…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Mounting Bracket Dimensions of Manual Pull-Out Step

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching