Distance From Hitch Pin Hole To Brace On the Curt Pintle Hook Mounting Plate C48341
Updated 06/26/2019 | Published 06/25/2019
Products Featured in This Question
Question:
what is the measurement from center of mount hole to the point where diagonal support brace meets the bar ? the video says the distance from mount hole top front of plate is 10 inches, but need measurement to the support brace
asked by: Jay
Expert Reply:
The distance from the center of the hitch hole to the beginning of the brace on the Curt Pintle Hook Mounting Plate part # C48341 is 3". If you need more than this then we have the B&W Pintle Hook Mounting Plate part # BWPMHD14004 which measures 4-5/8" from the center of the hitch hole to the beginning of the brace.
Product Page this Question was Asked From
Curt Pintle Hook Mounting Plate for 2" Hitches - 10" Shank - 14 Hole - 10,000 lbs
- Pintle Hitch
- Mounting Plate Only
- Adjustable Height
- 10000 lbs GTW
- 2 Inch Hitch Mount
- 14 Holes
- Standard Shank
- CURT
more information >
Continue Researching
- Q&A: Is it Safe to Flip the 10 Hole Cushioned Pintle Mounting Bar and Use The Top Set Of Holes To Tow
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: What Spindles Should be Used on Dexter 7k Trailer Axle
- Q&A: Short Shank Pintle Mount that has the Most Rise and Drop Adjustments
- Q&A: Replacement Mounting Hardware for Buyers Products 15 Ton Pintle Hook
- Article: Pintle-Hitches
- Q&A: Can a Pintle Hook Mount be Used in the Rise and Drop Positions
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Which Hitches are Made in the USA
- Article: My Trailer Hitch Doesn't Fit
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Raise Your Travel Trailer Height
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)