1,000 lb Slipper Spring Recommendation for John Boat Trailer  

I do have some options for you but none of our trailer axles match the exact measurements that you provided. Therefore, the best option we have for you would be to switch to an axle less system like the Timbren Axle-Less Trailer Suspension System…

Installing the U-bolts and plate like that would be fine, but I would recommend putting the plate on the leaf springs and running the U-bolts around the axle instead. The good news is you're replacing them so you can make that change when you…

The only 1-3/4" wide slipper spring we are going to have with a radius end rated for 1,500lbs is the 3-Leaf Slipper Spring #e99SR you found. If you cannot find the correct size you may have to move your Hanger #CE14017G to use these shorter…

The slipper spring should sit on the hanger bolt somewhere in the center of the flat part so that it allows a bit of movement as the suspension articulates. The curved ends will generally going to keep the spring from moving too far if the suspension…

The E-Z Flex Heavy Duty Rubber Suspension System part #K71-652-00 would not have much of an effect on irregular tire wear unless something was pretty blatantly wrong. The issue that is causing your tires to wear on the outer and inner edges sounds…

It's hard to see in your picture but is the hanger open on the one side which allows the spring to slide out to the side? It shouldn't be open like that. If you need a replacement hanger we have the #115706S for if you have a 1-3/4 inch wide…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

Hello Dickie. We meet again. The CE Smith Triangular Equalizer #CES86WR has nylon bushings. Pretty much all of the standard equalizer we carry come with nylon bushings pre-inserted. They would have to be pressed out to use with a bronze bushing.

Looks like you have slipper springs on your 2001 Coleman Utah pop up. We have replacement slipper springs available like the #e29SR which is 30 inches long and for 1,800 lb axles or the #SP-179275 which is 24-5/8 inches long and for 2,000 lb axles.…

Hey Steve, the longer crossbars part #MPG4001 can be used on the Ecolight trailer part #MAL53FR if you wanted as they are the same dimensions aside from length. This would give you the 78 inch long crossbars.

Hi Steven; take a look at the diagram below. Since your springs wear out over time it is best to use measurement D and E and match what is on your trailer. For the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR D is 12"…

You are correct, the 5.30x12 is the SAE nomenclature, while the 145/80-12 is the closest metric equivalent. The two are approximately the same size with the 5.3x12 being about a tenth of an inch narrower and a quarter of an inch taller than the…