Will Lippert Electric Landing Gear # LC333964 Fit 2006 Outback Keystone 29
Updated 04/24/2019 | Published 04/23/2019
Products Featured in This Question
Question:
Need to replace landing gear... will this one work?
asked by: Nicky
Expert Reply:
Most likely yes as the Lippert Electric Landing Gear Set # LC333964 you referenced is designed to fit the standard fifth wheel trailer mounting locations. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine. If not they can be rewelded as needed. This is by far the most popular setup seen on trailers.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Search Results: lc333964
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Q&A: Adding a Motor to an Older Fulton Landing Gear Set
- Q&A: Determining if Replacement Landing Gear Set Will Mount to Existing Brackets on Trailer
- Shop: RV Exterior Lighting
- Q&A: How to Measure to Pick Out Replacement Landing Gear for a Trailer
- Q&A: Replacement for Broken Landing Gear on 2010 Open Range 399BHS
- Q&A: Can Lippert Landing Gear Fit in Place of Jacks with 10-1/2 inch Bracket Dimension
- Q&A: Recommended Lippert Landing Gear Replacement For 6000 lb Gear On Cedar Creek 34SATS 5th Wheel
- Q&A: Determining The Correct Replacement Landing Gears For A 2020 Keystone Sprinter Limited 5th Wheel
- Shop: Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs