Third Brake Light Stop Lamp Isolation Converter Compatible with LED Lights

Question

Question:

Im simply adding a 3rd LED brake light to an enclosed trailer that came with LED brake/ signal lights. Its to my understanding this converter is required to isolate the third LED light from any signal functions. My question is: Will this converter work with the brake/ signal lights being LEDs? In other words, do the LED tail lights create enough electrical draw for the box to accept their input so it can do its thing with regards to the 3rd brake light operating only under braking conditions? Thank you for time.

asked by: Tom

0

Expert Reply:

To isolate the stop lamp from the turn signal for your third brake light if you have combined functions at your trailer tail light you would need the Pacer Performance 3rd Brake Light Logic Module # PP20-702 for the easiest converter. You won't have any issue with the power draw for this to function correctly.

expert reply by: Jason S

0

Answer 1

The EZ Loader with the BT150A Oil Bath hub uses a wheel bearing kit 300-020885 which includes wheel bearing part #L44649 for the inner and outer bearing, seal part #34823 and race part #L44610. From my research it looks like your hub is an idler hub,…

view full answer...

Answer 2

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

view full answer...

Answer 3

Hey Ron! For your 2025 Ford Maverick I recommend going with the Roadmaster InvisiBrake Flat Tow Brake System #RM-8700 with the Roadmaster Stop Light Switch Kit #RM87GR and the Roadmaster Brake-Lite Relay Kit for Towed Vehicles #RM-88400. For wiring,…

view full answer...

Answer 4

Hey Steve, thanks for reaching out! The Roadmaster Direct-Connect Base Plate Kit #RM87NQ fits your 2025 Ford Maverick as long as it's the Hybrid model that doesn't have the engine block heater. It doesn't come with the 6-Pin connector,…

view full answer...

Answer 5

If the vehicle you are towing with has separate stop and turn signals then it will need to be wired with a Modulite converter so that it can run the lights on the vehicle you are towing that does not have separate turn signals and stop lights. If the…

view full answer...

Answer 6

Hey Tom! I can definitely help you out. Demco has some nice products for flat towing so I'm sure you'll be happy going that route again. To flat tow your 2025 Ford Maverick you will need a base plate kit, tow bar, safety cables, wiring, and a…

view full answer...

Answer 7

To add a third brake light to a trailer is pretty simple, but does require an adapter to convert the signal. Because trailer tail light systems combine the stop lamp and turn signals for each side onto a single circuit, you will need to use a…

view full answer...

Answer 8

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

view full answer...

Answer 9

You could use light #STL79RB as a third brake light. Normally it is not recommended to mix LED lights at incandescent lights because the lights don't have voltage/amperage regulators and an incandescent light could draw too much power through an…

view full answer...

Third Brake Light Stop Lamp Isolation Converter Compatible with LED Lights

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching