Vehicle to Vehicle Tail Light Converter Review Video

Hey Keith, You could use the Vehicle to Vehicle Tail Light Converter #118158 you were looking at and connect the stop function to the third brake light and just cap off the the left and right turn signal wires on the output side since you won't…

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

I recommend using the Roadmaster wiring for your 2024 Ford Maverick because I've found it to be the most reliable on the market. The correct kit depends on if your Maverick has LED lights or not: - LED Lights #RM38FR - Non-LED Lights #RM-15267…

Hey Terry, this is a great question but I would assume due to the age of your SMI system and fact you have a hybrid now that has the different braking system it won't work. 20 plus years ago the braking system you have now was not around for SMI…

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

Do you have a 2000 VW New Beetle? If so there is a trailer hitch that fits both the Turbo and non-Turbo models, the Draw-Tite Sportframe Trailer Hitch Receiver #24679. I have added a link to a video of this hitch being installed on a New Beetle for…

The Optronics LED Clearance or Side Marker Trailer Light is available in Red #MCL0030RBB and Amber #MCL0030ABB. These are the closest replacements to the Glo Brite 122r/122y lights you have. The lights only have one LED diode versus the 3 in your…

The globrite 122 in red or yellow/amber are 3.75 inches by 1.70 inches from what I can find online. We do not have a direct replacement, however the closest dimension we have to replace them is 3-1/2 by 1 inch. I recommend the #MC68RB and #MC68AB. If…

You can use an isolating diode kit like #48955 to prevent tail light back-feeding in your flat towing set-up. Each stop and turn circuit (4 in total) will need a diode to allow signals to travel in only one direction, without back-feeding to the RV.

The way your 1988 Suzuki Samurai is currently setup, you have both combined and separate lighting systems. The combined system means the stop and turn signals are on the same circuit whereas the separate lighting system means the stop and turn…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I have included images below of the 6-Pin #PK11609 and the 7-Blade #C58155 connectors that you will be wiring. I do recommend using the positions rather than trying to go off the wiring colors as the colors can vary. You can use a Test Light #PTW2993…