Can You Use a DeeZee Wheel Well Toolbox with a Camper Shell on a 2007 GMC Sierra

Question

Question:

Will these toolboxes fit with a the ARE Z-Series Camper Shell on a 2007 New Body GMC Sierra Crew Cab Short Bed plus already have Line-X in bed.

asked by: Ryan

0

Expert Reply:

This DeeZee Side Wheel Well Toolbox # DZ94B that you referenced installs with brackets that bolt to the top rail of your bed wall. I attached a picture that shows how they would attach to your vehicle. You will need to compare that to how your camper shell installs on your vehicle to see if you will be able to use the two at the same time without interference.

If you camper shell installs into the stake pockets of your bed I would imagine you would be good.

The spray-in bedliner you have should not interfere.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hi Timothy; for your 2022 Chevy Silverado 1500 diesel we have the Draw-Tite Front Mount Trailer Hitch Receiver #DT44HR. This is the only front hitch without the diesel restriction.

view full answer...

Answer 2

We carry the Timbren Axle-Less System rated at 5,200 lbs part #ASR5200S01. The axle-less system mounts to your trailer frame and takes the place of your old axle and springs.#ASR5200S01 is a straight spindle design. Timbren also offers these axles…

view full answer...

Answer 3

To connect to the WiFi on the VueSMART RV and Trailer Backup Camera #HM34FR you will need to register the product through the Hopkins Towing Solution App and then you'll be able to connect to the VueSMART by using the password…

view full answer...

Answer 4

Only a 7-way trailer connector will have a 12-volt power wire ran to the connector. A 4-way trailer connector will not have a constant 12-volt power wire. As long as the 12-volt power wire running to the 7-way trailer connector is rated for the…

view full answer...

Answer 5

You are correct that the DeeZee Specialty Series Wheel Well Toolbox #DZ94B is intended for installation on the passenger side of the truck bed but if you prefer to mount it at the front of the driver's side of the bed, in front of the wheel well,…

view full answer...

Answer 6

Hey, Dave! Happy to help! You want to pick up #WT110108 for the front and #WT27JD for the rear. If you happen to have any sort of steps or running boards, you will want to make sure that there is at least 2" of clearance between any step or…

view full answer...

Answer 7

Depending on how the camper shell installs, you may be able to use the DeeZee Specialty Series Driver's-Side Wheel Well Tool Box #DZ95. The #DZ95 installs with brackets that attach to the inside of the bed rail as you can see in the cut out of…

view full answer...

Answer 8

I spoke with my contact at DeeZee, who did not have any information as to whether or not the box would fit in front of the wheel well, rather than in its typical installation behind it. However, the foot or bottom of the box is 17 inches in length.…

view full answer...

Answer 9

If you want a single item that can both store tools and supply additional fuel capacity for your Ram 3500 long bed you might consider the DeeZee Combo Auxiliary Tank #DZ92740X. This unit combines a 43-gallon tank and a tool chest in one product that…

view full answer...

Answer 10

I would be happy to help narrow down the choices to the best hitch for your 2021 Ram 1500 Classic Warlock edition. Since your main purpose will be for accessories, I recommend the etrailer Hitch Receiver item #e98852. This hitch is custom fit and…

view full answer...

Answer 11

The Draw-Tite Ball Mount w/ 2" Ball for 2" Hitches - 3/4" Rise, 2" Drop - 7,500 lbs item #DT49MR you were looking at would work great to haul a 6 x 12 uhaul trailer. The trailer has a maximum 4,400 lbs capacity which would not…

view full answer...

Can You Use a DeeZee Wheel Well Toolbox with a Camper Shell on a 2007 GMC Sierra

Product Page this Question was Asked From

Continue Researching