What is Gauge of Wire Used for Side Marker Light with Reflector # MC36RB
Updated 03/12/2019 | Published 03/11/2019
Question:
Hello I have these lights on my trailer right now which are Optronics Trailer Lights - MC36RB. I would like to add some more but don’t know what size gauge wire I should use to tap into the existing wire. The trailer is a triple crown 7x16 utility trailer, it has a 7 way plug on it as well. Thank you for all your help.
asked by: Victor C
0
Expert Reply:
The gauge of wire that the Square Trailer Clearance, Side Marker Light with Reflector # MC36RB uses is 18 gauge. To be safe you may go ahead and use a heavier gauge wire.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Square Trailer Clearance, Side Marker Light with Reflector - Red
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-3/4L x 2-1/8W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Tie Down Side-Mount Spare Tire Mount Fit 3" Tall Trailer Tongue
- Q&A: Circuit Tester for Testing Trailer wiring Circuits
- Q&A: RV Power Cord with 4-Prong Twist-Lock and 3-Prong Connectors
- Q&A: Overall Length of MORryde U-Bolts # MR66ZR
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Where Is the Brake Controller Plug On a 2021 Ford F-150
- Article: Ram Trailer Tow Prep Package
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams