Installing LED Trailer Light with Black, Red, and Green Wires
Updated 02/12/2019 | Published 02/10/2019
Products Featured in This Question
Question:
I got set of led that have red green and black wire I was wanting to know if you have seen this color combo and how wire them
asked by: James
0
Expert Reply:
Typically with an LED light that has a black, red, and green wire the black wire is for ground, the red wire is for the turn/brake light circuit, and the green wire will go to the running lights circuit on the trailer.
If you can tell me what model LED lights you purchased I will be happy to verify this for you.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Tail Light - 6 Function - Submersible - 18 Diodes - Square - Red - Passenger
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Marker
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5-1/4L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: How to Install Trailer Light with Red, Black, and Green Wires
- Q&A: Replacement Passenger Side Miro-Flex LED Trailer Light 38 Diode
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Is the Bezel Included w/ the Miro-Flex LED Trailer Side Marker?
- Article: Trailer Tire Sizing
- Q&A: Where To Connect Two White Wires From Brakes on Trailer Axle
- Q&A: Comparing Fulton XLT and Dutton Lainson 2 Speed Winch
- Q&A: What Size Cut Out For Recessed Led Light
- Q&A: How to Measure for a Replacement Axle, Hubs, and Leaf Springs for a Boat Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: Trailer Wiring Diagrams