Swing Away Hitch Extender for 1Up Bike Rack
Updated 02/04/2019 | Published 02/02/2019
Question:
The OneUP does not have a traditional mount system in that there is no cross hole in the tongue that fits into the receiver. Therefore the depth of the 2” receiver is important. How far will a 2” tongue go into the receiver before it bottoms out?
asked by: Bruce
Expert Reply:
I reached out to a representative of Yakima who said that the Yakima BackSwing Swing Away Hitch Extender # Y02483 had a receiver that had a depth of 8 inches and was 2-1/2 inches from the edge of the receiver to the center of the hitch pin hole.
The accompanying diagrams show measurements of the Yakima BackSwing # Y02483.
I have added a link to a video review of this swing away extenders for you to check out as well.
Product Page this Question was Asked From
Yakima BackSwing Swing Away Hitch Extender for Bike Racks - 2" Hitches
- Hitch Adapters
- Swing-Away Hitch Adapter
- Bike Racks
- Fits 2 Inch Hitch
- 250 lbs
- Yakima
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Which Swing Away for Bike Racks Would You Say is Beefier in Design the Kuat or Swagman?
- Q&A: Recommended Swing Away Hitch for a Toyota Sienna
- Q&A: Hitch Extender for 2025 Land Rover Defender With Rear Mounted Spare and Hollywood Racks Bike Rack
- Q&A: Correct Voyager WiSight Camera for Installation on a 2022 Winnebago Prewired for Voyager Camera
- Q&A: Will the Swagman Swivel Hitch Extender Swing Out to 180°?
- Q&A: Arm Dimensions for the Swagman Swivel Hitch Extender
- Q&A: Will Swing-Away Hitch Extender Hold Bike Rack With E-Bikes
- Article: How to Mount a Truck Bed Camper
- Article: Anti-Rattle Devices
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks
- Article: How to Choose the Right Trailer Hitch Class
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Trailer Hitch Drop