What is the Standard Roof Size Opening for RVs
Updated 01/07/2019 | Published 01/05/2019 >
Question:
It looks like most of your roof vents for a camper fit a 14x14 inch hole. Do you have any that would fit a 10x10in hole? If you dont have that, I could make the hole a bit bigger, and could use a 12x12, do you have any that size?
asked by: Louis D
Expert Reply:
The standard RV roof opening is 14 by 14 inch, if there was a way you could open your roof to that size you could pretty easily install a roof vent like the Ventline Roof Vent w/ 110V Fan # V2128SP-01 that you referenced. But we do not have anything that's designed for a 10 by 10 or 12 by 12 inch opening.
Product Page this Question was Asked From
Ventline Roof Vent w/ 120V Fan - Manual Lift - 14-1/4" x 14-1/4" - White - Polar Trim
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 120V Fan
- Plastic and Metal
- White
- Ventline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Step Wet Bolt for 1-3/4" Double Eye Springs Suspensions
- Q&A: Do You Have a Powered Roof Vent that Can Be Powered by 120v Outlet?
- Q&A: Can MaxxFan Deluxe Roof Vent Run Off Battery Powered by Solar Panel
- Q&A: How to Install a Ventline Ventadome Roof Vent with 12 Inch Fan Powered Lift
- Q&A: Adding a Fan to the Vent of a Lance Truck Camper
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: Replacement for MaxxAir Circuit Board 10B21276KZ
- Article: How Much Solar Power Do I Need For My RV?
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Replace an RV Roof Vent Cover


