Troubleshooting Trailer Wiring Where Left Stop/Turn Circuit Activates Both Sides of Trailer
Updated 12/26/2018 | Published 12/22/2018 >
Question:
Why are both indicators working when I go left indicator, but when I go right there is nothing?
asked by: Shannon
0
Expert Reply:
You must have the left stop/turn circuit ran to both sides of your trailer which is causing the both blinkers to come on when the left circuit is applied and none when the right side is on. You'll want to go over the wiring of the trailer wiring to find the right stop/turn circuit and run it to the right side. Most likely it's a green wire that will be ran to the right side and a yellow wire ran to the left side.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Difference Between A35WB And A35W42B 35 ft. Wishbone 4-Way Trailer Wiring Harness
- Q&A: What Wire Gauge Is The TowSmart 16 to 18 Gauge, 4 Conductor Wire?
- Q&A: Recommended Bolt On 7,000 lbs Capacity Square Jack
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Which Grease Seal would Fit Dexter 7k Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: How to Measure Your Trailer Wheel Bolt Pattern

