Troubleshooting Kwikee Revolution Steps that Buzz for a Few Seconds at End of Cycle

Updated 03/16/2020 | Published 12/15/2018

Products Featured in This Question

Replacement Motor for Kwikee Revolution Series Electric RV Steps - 12V

(80)

$291.19

Replacement Steps, Motor, and Control for Kwikee RV Electric Steps - Revolution Series

(62)

$917.02

Question:

Thanks for helping me. I have a Kwikee Revolution 2 step LC3725791 for my 2014 Vista Winnebago. When it goes out it buzzes loudly at the end of the cycle for 2-3 seconds. Its fine going in. It also seems to not lock and can be pulled out another 1/2 inch . I notice that there is some play on the cam joints but I hate to add washers and get it too tight. It has play side to side . The step control was new in August and the step motor new this September. The new motor wasnt the exact one but we were on the road and couldnt get in at a RV dealer. The motor had worked just fine in every way till it sat for 2 months and now its cold. I just ordered the the proper one from E- Trailer yesterday LC380073 but am hoping its the cold in Minnesota thats causing the buzz in the 2 month old motor. Any ideas on what to do or try? Thanks so much. I can sure send photos if needed.

asked by: Rich O

Expert Reply:

I spoke with my contact at Lippert who said that using the correct motor (part # LC380073) will help to fix the issues you are having with your Revolution Power Step # LC3725791 but you will also need to adjust your cams to remove some of that play you mentioned.

If you are still having issues after replacing your motor and adjusting your cams just let me know and I can help you troubleshoot further.

expert reply by: Jon G

Bob G.

3/14/2020

Have a model 38 kwikee step that keeps one trying to retract when its closed. Does same when it opens.

Chris R.

3/16/2020

It sounds like there could be an issue with the switch wiring. The Kwikee Electric Steps are supposed to extend and retract with the door opening, so this particular circuit may be mis-wired or loose. Look for any signs of damage on the wiring as well like exposed or frayed portions that need to be replaced. Let me know what you find and we can go from there.