Correct Bearing Buddy for the Trailer Idler Hub Assembly Part # AKIHUB-440-2-2K
Published 10/18/2018
Products Featured in This Question
Question:
the bearing buddies were the correct size. The one issue I do have is that the grease seal that was shipped did not fit the spindle, the interior dimension was too big. Based on the spindle width and the existing bearings I had (L44649) all indications led me to believe 1.06 was the correct size which it appears to be. Just not the grease seal. Can you send me the correct seal?
asked by: Chris
Expert Reply:
Yes, the correct Bearing Buddy Bearing Protectors for the Trailer Idler Hub Assembly part # AKIHUB-440-2-2K is part # BB1980A-SS for stainless steel or part # BB1980A for chrome plated.
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44649 Bearings - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Pre-Greased
- Standard
- L44649 / L44649
- Standard Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Hubs for 1" Straight Spindle With 5 on 4-1/2 Bolt Pattern Using 13" Wheels.
- Q&A: How Much Does The etrailer Hitch e58ZV For A 2025 Kia Niro Weigh?
- Q&A: Replacement Hub For BT-100 Trailer Idler Hub On a 1" Straight Spindle
- Q&A: What Does BTR and BT8 Mean when Picking Out Replacement Trailer Hub
- Q&A: Is Norcold 12V RV Mini Fridge A Good Choice For Lance Truck Camper Off-Grid
- Q&A: Replacement Hub Assembly for Older Boat Trailer with 4 Bolt Pattern
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Slipper Spring Trailer Suspension System Review
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Article: How to Tell the Weight Rating of a Trailer Axle
Chris
10/18/2018
the bearing buddies were the correct size. The one issue I do have is that the grease seal that was shipped did not fit the spindle, the interior dimension was too big. Based on the spindle width and the existing bearings I had (L44649) all indications led me to believe 1.06 was the correct size which it appears to be. Just not the grease seal. Can you send me the correct seal?