Does Tang Washer Go Between Spindle Nut and Hub Washer
Published 09/04/2018 >
Question:
My EZ Lube type axle had the tang washer under the spacer washer, that is, it was pushed on first, then the spacer was, so the spacer sits against the inside of the castle nut. Your video shows it on top of the spacer, closest to the nut. Which is correct? I suppose if the spacer is stronger, then maybe having it against the nut will reduce wear?
asked by: Peter I
0
Expert Reply:
You'd want the tang washer like the # 5-101 that you referenced between the washer and the nut.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Spindle Washer - Tang Type for E-Z Lube
- Accessories and Parts
- Trailer Spindles
- Spindle Washer
- 1 Inch I.D.
- TruRyde
more information >
Continue Researching
- Search Results: tamper proof screws
- Search Results: trailer hubs and drums
- Search Results: trailer flooring
- Search Results: pace trailer parts
- Search Results: trailer brakes
- Search Results: brake hubs
- Search Results: castle nut retainer
- Video: Review of Specialty Recreation RV Sinks - Bathroom Sink - SR29YR
- Q&A: Bearing Kit Recommendation for 2018 Jayco with 3,500 Lippert Axles
- Shop: BTBRV Magnetic Hitch Receiver Reducer Set - 3" to 2-1/2" & 2-1/2" to 2"
- Shop: Replacement Spindle Washer - Tang Type for E-Z Lube
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Video: Review of Lippert Trailer Axles - Trailer Spindles - LC45RP
- Shop: Lippert Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 5" - Pre-Greased
- Shop: Specialty Recreation RV Flip Sink - 18" x 24" - Wet Bath
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 6 on 5-1/2 - Pre-Greased
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Video: Detailed Breakdown of the Replacement Spindle Washer
- Q&A: Method for removing and Installing Tang-Style Spindles Washers
- Video: Review of Dexter Trailer Axles - Trailer Spindles - Trailer Suspension Parts - DX82CR
- Q&A: What Diameter Thread Are The DX82CR Spindle Retainer Nuts?
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Video: Timken Bearing Kit Installation - Enclosed Trailer
- Video: A Closer Look at the Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles
- Q&A: Do Clazzio Custom Seat Covers Interfere with Air Bag Deployment
- Video: Breaking Down the D Washer for EZ Lube Spindles
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Is a 1600 psi Brake Actuator too Much for Kodiak 10 Inch Disc Trailer Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: 7 Common Questions Everyone Has About Trailer Tires


