How to Combine Taillight Circuits Stop and Turn Onto One Circuit
Updated 08/21/2018 | Published 08/20/2018
Products Featured in This Question
Question:
I have 04 dodge ram 3500 put flat bed on it With led lights. When wireing into the harness the turn signal is on a separate wire from brake wire. How do i wire this up
asked by: Mike
0
Expert Reply:
If you wanted to combine your separate turn signals from stoplights for wiring in the Thinline LED Trailer Light part # STL59RB all you'd need is a converter like part # RM-732 and you'd be set. If you wire in the correct signals on the input side of the box the output side would have the signals combined.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Strip Light
- Surface Mount
- Submersible Lights
- LED Light
- 12-1/2L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Are Powder Coat Trailer Wheels Good for a Saltwater Boat Trailer ST205/75R14
- Q&A: Aluminum Ramp Upgrade That Folds Up And Down For Big Tex 7 Foot Wide Car Hauler Trailer
- Q&A: Can Aluminum Trailers Ramps In RapidRamps Kit Be Adjusted For Different Width Vehicles?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Battery Disconnect Solution for 2017 GMC Sierra 2500 Diesel with Two Batteries
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: How to Determine Which Drawbar I Need For My Vehicle
- Q&A: Replacement for Dexter Grease Seal 010-019-00
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)