Are the Ends of an RV Surge Protector Replaceable
Updated 08/06/2018 | Published 08/04/2018 >
Question:
can you replace just a female end plug if it got burned due to pulling to many amps
asked by: Steve
Helpful Expert Reply:
It would not be smart to replace the female and or male end on any electrical extension or adapter. If a short occured to the point where an end was burned and or melted then it will be imperative to replace the entire unit as there is most likely something else that has shorted that would either not allow the extension or adapter to work or cause another failure, perhaps more catsophic than the first.
I have attached a list of our RV wiring adapters for you. Let me know if you need help picking the correct one.
Product Page this Question was Asked From
Camco RV Power Defender Circuit Analyzer Dogbone - 125V - 30 Amp
- RV Surge Protector
- Circuit Tester
- 30 Amp
- Portable
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution System And Brake Controller For Towing A 2022 Forest River No Boundaries NB19.2
- Q&A: Recommended Flat Towing Parts for a 2021 Jeep Grand Cherokee
- Q&A: Benefit of Internal TPMS System Vs. Cap Sensors
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Q&A: Replacement Converter for your Magnetek Converter Series 6300 Model 6332
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Q&A: Can you Back Up With the Weigh Safe Weight Distribution Hitch Before Making the Adjustments?
- Article: 4-Step Guide to Installing RV Solar Power
- Q&A: Best 5th Wheel Hitch For 2024 Chevy 2500 4dr Crew Cab With 6-3/4' Bed
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: RV Electrical Power Systems
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)

