Rear Axle Air Spring Kit and Compressor Kit for 2013 Toyota Sienna AWD

Question

Question:

Is this system compatible with the AWD version of the 2013 Sienna?

asked by: Jason M

1

Helpful Expert Reply:

Yes, the Air Lift rear-axle air bag suspension kit # AL60732 will fit your 2013 Toyota Sienna with all wheel drive and it also fits the 2WD models as well. An installation video and the written instructions are linked for you.

This type of helper spring kit can go a long way toward reducing the rear-end sag in vehicles like the Toyota Sienna and Honda Odyssey that tend to have low-slung suspensions. This kit will provide useful stiffening of the rear suspension to help reduce bottoming out from either cargo or trailer weight pushing down the rear of the vehicle.

More often than not vehicle owners who are installing a rear air spring kit like this also opt for a compressor kit to make it easier to control air bag pressure. Manual inflation at a gas station is fine if you don't mind pulling over and paying for air service, but the true bonus of using an on-board compressor like # AL25592 is that you can easily find the bag's pressure "sweet spot" when you can make these adjustments on the fly as you drive.

expert reply by: Adam R

1

Answer 1

You can install the Air Lift AirLift 1000 Air Helper Springs for Coil Springs #AL60732 on your 2013 Toyota Sienna with the protector on either top or bottom, depending on the direction you want the air hose to be. The protector will be on the bottom…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hello William, Thanks for writing in, you are correct the Firestone #F4155 is not a good fit for the 2021 to 2024 Sienna Hybrid. The hybrid models have some key differences in the rear suspension area due to battery placement and tighter coil spring…

view full answer...

Answer 6

Hey Nathaniel, thanks for your question. The Firestone Coil-Rite kit #F4155 is only designed to fit 2-wheel drive models, so it would not be the correct fit for your AWD Sienna. For your AWD model, the correct option is the Air Lift 1000 Air Helper…

view full answer...

Answer 7

Trailer wiring like the #C56106 that you reference attaches to the vehicle's battery directly as a way to bypass all of the vehicle's delicate wiring circuits to draw power for the trailer's wiring. If you ran the power wire to a circuit…

view full answer...

Rear Axle Air Spring Kit and Compressor Kit for 2013 Toyota Sienna AWD

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching