How Does Oil Fill into Hub that Uses Kodiak XL ProLube Kit
Updated 07/25/2018 | Published 07/24/2018
Question:
If I were to use these with K2HR35D how would I fill the hub with oil? Is there a port to add oil on these or do I need one on the hub itself?
asked by: Corey
0
Expert Reply:
The black center plug that you see on the plastic cap of the Kodiak XL ProLube Kit for 3500-lb Axles # XLPROLUBE1980KIT that you referenced is the fill hole.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kodiak XL ProLube Kit for 3500-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 1.99 Inch
- 3500 lbs Axle
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Can Regular Grease Trailer Hubs be Converted to Oil Bath Hubs
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: How do I Change My Ez-Lube Hubs to Oil Bath Hubs on My 7k Axles?
- Q&A: Converting to Oil Bath Hubs on #84 Trailer Spindle
- Q&A: Are Trailer Brakes Interchangeable Between 7k and 8k Axles
- Q&A: Can Kodiak XL ProLube Kit Work on 7,000 lb. Idler Hubs
- Q&A: Could Kodiak XL ProLube Kit XLPROLUBE2440KIT Fit 7,000 lb Dexter D70 Hub
- Q&A: Recommended Disc Brake Conversion Kit for a 2019 Grand Design Solitude 373FB
- Article: Best Boat Trailer Jacks
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop