What is the Length and Diameter of the Pins in the CURT Spring Bar Retainer Package
Updated 09/22/2011 | Published 09/21/2011
Question:
what is the diameter and length of the pins in this kit. thanks
asked by: Mitch W
0
Expert Reply:
I went out to the warehouse and pulled a CURT Spring Bar Retainer Package, # 17109, to measure the pins. I used a set of digital dial calipers to take the measurements. Each pin is 0.724 inches long and has a diameter of 0.313 inches. The kit is designed for CURT Round Bar Weight Distribution systems.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Continue Researching
- Q&A: Replacement AC for ARC13AACBL2
- Q&A: Square Trailer Jack Compatiblility With Electric Motor Kit
- Q&A: Recommended Round Bar Retainer Clips for Weight Distribution Head
- Q&A: Adding an Electric Motor to Bulldog Square Jack # BD182701
- Q&A: Is The Mopar Recreational Flat Tow Wiring Kit Part 68321424AB Required To Flat-Tow a Jeep Cherokee
- Q&A: Removing and Reinstalling New Retainer Pins in Fastway Weight Distribution System
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Hitch Installation Tips