Available Erickson E-Track Wheel Chocks
Updated 07/10/2018 | Published 07/06/2018
Products Featured in This Question
Question:
I bought 2 pair of the EM09162-2 wheel chocks and the Chocks will not fit on my e-track. the E-Track is flush or slightly below the trailer finish floor. The E-Track Chock are too wide, do the make a Chock that is the same width as the E- Track
asked by: GART
Expert Reply:
Erickson offers only one size of E-Track wheel chock which measures 8-1/2 long x 6-3/8 wide x 4-1/2 tall. This is offered as a single chock under part # EM09162 and as a pair under part # EM09162-2.
Erickson does offer a wheel chock and tie-down kit for ATVs, part # EM09160, which uses bolt-on chocks that attach directly to a trailer's deck (not to E-Tracks). With your finished floor setup this might be a better option.
Product Page this Question was Asked From
Erickson E-Chock Wheel Chocks for E Track - Powder Coated Steel - Qty 2
- E Track
- E Track Wheel Chocks
- Erickson
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Recommended E-Tracks and Straps for Towing a 4,000 lbs Car
- Article: Trailer Wiring Diagrams
- Q&A: Can E-Track be Installed in Car Hauler for Multiple Car Widths
- Q&A: Do I Have To use All Bolt Holes of E-Track ATV Tie Down Kit
- Q&A: Backing Plates And Wheel Straps For Securing Vehicles In Enclosed Trailer With E-Tracks
- Q&A: Number of Backing Plates Needed For 5 Foot Long E-Track
- Q&A: Will etrailer RV Cover part # e99VV Work in Wet and Winter Weather
- Q&A: Can E-Track be Flush or Recess Mounted Instead of Surface Mounted
- Article: Trailer Lighting Requirements
- Article: Rust Prevention
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy