Towing System Compatible with 2017 Ford Edge Titanium

Published 06/18/2018

Products Featured in This Question

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2273)

$49.29

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(95)

$71.58

No-Drill Mount for Electrical Mounting Bracket - Short

(1180)

$21.57

Mounting Bracket 4-Pole Flat

(6112)

$10.07

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(334)

$36.80

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(25)

$222.60

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2932)

$2.73

Question:

I have a 2017 Ford Edge Titanium. Will a 2-inch ball fit this reciever hitch?

asked by: David H

Expert Reply:

The Curt Trailer Hitch Receiver - Class II # C12140 is a confirmed fit for your 2017 Ford Edge Titanium. Then you can use ball mount # C45521 you asked about along with 2 inch hitch ball # A-82 and pin/clip # F-4.

For your trailer wiring, I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118677. This custom-fit T-One connector plugs into your Ford Edge's wiring harness, which is located behind the driver's-side and passenger's-side tail lights. Once you've plugged in the T-connector, run the hot lead up to your car battery. Connect the lead to the included fuse holder, and then connect the fuse holder to the positive terminal on your battery and insert the provided fuse. Once installation is complete, the 4-way connector will be stowed beneath your Ford Edge, near the trailer hitch. Use mounting bracket # 18144 and # 18140 for a clean look.