5/8 Pal Nut Needed for 6-3/4 Long Roler Shafts with 5/8 Diameter
Updated 06/15/2018 | Published 06/14/2018
Products Featured in This Question
Question:
I need 6 pal caps. Can I purchase these without buying the roller shafts too? The shafts that I have are 6 3/4 inch long. I don t see any that size in your listing. Can longer ones be cut to size?
asked by: Erich C
0
Expert Reply:
The Roller Shaft with Pal Nuts Kit # CE10725A includes pal nuts that fit a 5/8" diameter shaft. We actually don't have these available separately as part # CE10801. Just change the quantity to 6 before adding the product to your cart and you are ready to check out!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Roller Shaft with Cap Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 8-7/8" x 5/8"
- Boat Trailer Parts
- Rollers
- Roller Shaft
- 5/8 Inch Diameter
- Zinc-Plated Steel
- 8-7/8 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: How Does the CE Smith Single Axle Trailer Fender Attach to the Trailer?
- Q&A: What Grease is Recommended for Gears of Boat Trailer Winch
- Q&A: Can The Yates Keel Pad YR1203SB Be Used To Cover V-Block On Boat Trailer?
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Q&A: Parts Needed to Install the CE Smith Single Axle Trailer Fenders w/ Top and Side Steps
- Q&A: What Hardware Is Needed To Mount CE Smith Panel Bracket CE10305G For 12" Keel Roller?
- Q&A: Replacement for 11-1/4" Keel Roller with Shaft and End Caps
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Article: Trailer Wiring Diagrams
- Article: Spring Towing Readiness Checklist
- Article: Trailer Maintenance Schedule
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing