Spindle Nut Washer and Grease Seal for a Dexter 3500 Pound E-Z Lube Trailer Axle
Updated 08/22/2011 | Published 08/19/2011
Products Featured in This Question
Question:
Looking for the spindle nut lock washers for a Dexter #3500 ez-lube axle. It is on a 2001 US Cargo open car hauler. Which part is correct part number a Redline 5-71 or a TruRyde 5-101? What is the part number for the seal for it as well? Thanks
asked by: Darrin
Expert Reply:
The Replacement Spindle Washer, # 5-101, was designed specifically for E-Z Lube axles, so that should be the correct washer for you. You can make sure that your spindle has a 1 inch diameter at the end where the washer will be.
It sounds like you have a #84 spindle which is for 3500 pound E-Z lube axles. The correct seal would be # RG06-050, for a pair of double lip seals. To be sure, you would need to find the bearing numbers of the inner and outer bearings. The numbers are stamped into the metal.
Product Page this Question was Asked From
Tang Replacement Spindle Washer
- Accessories and Parts
- Trailer Spindles
- Spindle Washer
- 1-1/2 Inch I.D.
- Redline
more information >
Continue Researching
- Q&A: Does Dexter Trailer Idler Hub Assembly for 12,000-lb Axles Come with Spindle Nut
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Is etrailer Still Carrying Draw-Tite Hitches
- Q&A: Dexter D120 Axle Replacement Parts
- Q&A: Availability of 72 inch Long Tandem Axle Trailer Fender in Diamond Plate
- Q&A: Replacement Oil Seal For Dexter 10,000 lb Hub From 2006 to Replace National 370150BG
- Article: Most Popular Wheel Bearings
- Article: How to Fix a Bad Trailer Ground
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Brake Controller Installation: Starting from Scratch