What are the Functions of the Pins for Pollak Rocker Switch # PK34310
Updated 02/13/2018 | Published 02/11/2018
Question:
I NEED TO KNOW THE WIRING DIAGRAM FOR THE TERMINALS. which TERMINALS ARE IN AND OUT. WHICH HOT WHICH GROUNG. tHANKS
asked by: KEVIN
0
Expert Reply:
I spoke with my contact at Pollak about this switch. If looking at the back of the switch, # PK34310, with the light on the bottom of the switch the top left is 12 volt power in, bottom left is power out. Top right is 12 volt power to light the switch and bottom right is the ground.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 4-Blade - Red Pilot Light
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Continue Researching
- Q&A: How To Secure and Wire the ThermaHeat RV Holding Tank Pads
- Q&A: Wiring Multiple Heating Pads to Switch Diagram
- Q&A: Recommended Air Pressure for Air Bags on 2000 F-53 Chassis Motorhome
- Q&A: Replacement Atwood Water Heater # GE16TE in Motorhome
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: Using Insulation Along with RV Freshwater Tank Heater Pad
- Q&A: Is Sealant Required for the Replacement Rubber Grommet for RV Black Water Tanks
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch