Is Using a Steel Crossmember Required When Installing Timbren Silent Ride Suspension Kit
Updated 01/30/2018 | Published 01/28/2018
Question:
Listing reads that in order to install this system a 2x2 steel crossmember must be utilized. I can see where the crossmember installs on other Timbren systems, but where would it install on this system?
asked by: Bruce H
0
Expert Reply:
I attached a picture that I took from the instructions that shows where the 2x2 crossmember attaches on the Timbren Silent Ride Suspension for Single Axle Trailers # TSR3500S05.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Timbren Silent Ride Suspension for Single Axle Trailers w/ 2" Square Axles - 3,500 lbs
- Trailer Suspension Parts
- Leaf Spring Replacement System
- Camper
- Car Hauler
- Utility Trailer
- 3500 lbs
- Square Axle - 2 Inch
- Single Axle
- Timbren
more information >
Continue Researching
- Q&A: Replacement 3,500 Pound Axle for Converted Military Trailer
- Q&A: Is There a 4-Way Wiring Harness for a 2026 Chevy Equinox Activ?
- Q&A: Replacement for Lippert 3,500 Pound 93 Inch Long Axle with 70 Inch Spring Seat Length
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: It The Big Truck Big RV Tongue Weight Scale Hydraulically Operated?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: How is Vehicle with 4-Way Converted to 5-Way for Trailer Reverse Lights
- Q&A: Highest Speed Rating for a 4.80 x 12 Trailer Tire
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Big Truck Big RV