Replacement Stud Recommendation for Dexter 6k Rated Trailer Hubs
Updated 01/29/2018 | Published 01/28/2018
Products Featured in This Question
Question:
what length do i need
asked by: Steve T
0
Expert Reply:
For Dexter 6k rated hubs like the part # 8-201-9UC3-EZ you will need to use stud # 165995. This drive-in stud is 2-1/2 inches long.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb Axles - 6 on 5-1/2 - Pre Greased
- Trailer Hubs and Drums
- Hub with Drum
- Pre-Greased
- 25580 / 15123
- Standard Grade
- For 5200 lbs Axles
- For 6000 lbs Axles
- 1/2 Inch Stud
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Dometic Soft Start for Dometic B59516.711C0-MX
- Q&A: How to Add Timbren Axleless Suspenion to a Trailer and Use 5 x 5 Lug Jeep Wheels
- Q&A: Victron Smart Dongle vs Cerbo GX Explained for MultiPlus-II Remote Control
- Q&A: Can A Hub With A 15123 Bearing Be used To Replace A Hub That Used An LM67048 Bearing?
- Q&A: Replacement Brakes, Hubs, Bearings and Seals for 2022 Conqueror UEV490
- Q&A: Wiring Diagram for Installing the Replacement Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: What are the Correct Bearings and Races for Dexter 8-201 Electric Drum Brakes?
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)