bing tracking image
Q & A Icon

Pre Greased Easy Grease Trailer Hub Installation and Spindle Grease Recommendation  

Updated 08/18/2026 | Published 08/08/2026

Question:

Can you confirm your part Part Number: AKIHUB-545-2-EZ-2K Easy Grease Trailer Idler Hub Assembly for 2K Axles - 10 to 12- 5 on 4-1/2 - Pre-Greased comes with bearings already packed with bearing grease, so no additional bearing grease is necessary? Arent you supposed to apply a thin layer bearing grease to the axle spindle before you slip the hub on? Thanks, Jim

0

Expert Reply:

Hi Jim, yes, the Easy Grease Trailer Idler Hub Assembly, part # AKIHUB-545-2-EZ-1K, comes pre greased with the bearings already packed, so you don’t need to pack the bearings with additional grease before installation. You are also correct about the spindle, though. I would still put a light coating of clean bearing grease on the spindle before sliding the hub into place.

That little bit of grease on the spindle helps everything slide together smoothly and provides some protection against corrosion. You can use the Dexter Multipurpose High Temperature Lithium Grease, part # DX37VC, for that. Just a thin coating is all you need since the bearings themselves are already packed and ready to go.

Are you replacing both hubs on the trailer while you’ve got everything apart, Jim?

expert reply by:
0
Heather A
James K. profile picture

James K.

8/17/2026

Grease compatibility question: Is Valvoline Extreme Red grease, NLGI GC-LB rated, compatible with the grease used in the DEXTER hubs? Please advise? Thanks, jim

Heather A. profile picture
Etrailer Expert

Heather A.

8/18/2026

@JamesK Hi Jim, yes, the Valvoline Extreme Red grease you mentioned is compatible with the grease used in Dexter hubs. Valvoline identifies Extreme Red as an NLGI #2 lithium complex grease with a GC-LB rating, and Dexter specifies an NLGI #2 lithium complex grease for its wheel bearings. Dexter cautions against mixing different grease thickener types, but since the Extreme Red uses the same lithium complex thickener type, you’re good to use it here. Since you already have the Valvoline grease on hand, are you planning to use it for both hubs, Jim?

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>