Wheel Well Toolbox Recommendation for Fitting In Front of Wheel Well
Updated 12/13/2017 | Published 12/12/2017
Question:
I want to mount behind the cab on drivers side not behind the fender
asked by: Gene P
Expert Reply:
To fit a wheel well toolbox on the driver side in front of the wheel well you'd have to go with one intended for the passenger side since you'd have to flip the box around. This will allow you to open the box easier and not have to reach over the open lid. The lid will open up to you then. If you have a long bed truck the part # DZ94 would work well for you.
If you have a short bed though you may not have the needed clearance between the wheel well and the front of the box.
Product Page this Question was Asked From
DeeZee Specialty Series Passenger's-Side Wheel Well Tool Box - Aluminum - 2.2 Cu Ft - Silver
- Truck Tool Box
- Wheel Well Tool Box
- Passenger Side
- 19-1/2 Inch Tall
- Aluminum
- 8 Inch Wide
- 37 Inch Long
- Silver
- DeeZee
more information >
Continue Researching
- Q&A: What Does Curt Hitch # C13024 Weigh
- Q&A: Using DeeZee Wheel Well Tool Box In Front of Wheel Well on 2011 Dodge Ram
- Q&A: Will the B&W Continuum Hitch Have Ground Clearance Issues on a Steep Driveway?
- Q&A: How To Secure DeeZee Storage Box In Toyota Tacoma Bed
- Q&A: Trailer Hitch Fit Recommendation for 1988 Toyota 4Runner
- Q&A: Will Curt Hitch Receiver Fit a 1986 Toyota 4Runner
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Determining Trailer Tongue Weight
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Sway Control, Stabilization, and Suspension Enhancement