Anti-Rattle Device Recommendation for Ball Mount In Trailer Hitch
Updated 11/29/2017 | Published 11/28/2017
Question:
How do I take the slack out of a tow bar hook up at the receiver? Connection seems sloppy.
asked by: Bruce
Helpful Expert Reply:
What you need is an anti-rattle device like part # 63232. What this does is install in the hollow ball mount shank you have and pulls the ball mount to the hitch to remove the sloppiness. Also this has a lock built into it which makes a theft deterrent as well.
As long as you have a 2 inch hitch and your ball mount has a hollow shank this would work well for you. If you have a different setup email me back with it and I'll see what would work best.
Product Page this Question was Asked From
Anti-Rattle Trailer Hitch Receiver Lock for 2" Hitches - 3-1/2" Span
- Trailer Hitch Lock
- Universal Anti-Rattle Lock
- Keyed Unique
- Fits 2 Inch Hitch
- Spring-Loaded Pin
- 3-1/2 Inch Span
- Lets Go Aero
more information >
Continue Researching
- Q&A: Best RV Rated Cargo Carrier Option for Cooler, Generator and Bikes
- Article: How to Measure for Trailer Hitch Drop
- Article: Anti-Rattle Devices
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Ball Mount Recommendation for Chevy Colorado Towing Scamp Travel Trailer
- Q&A: Recommended Cargo Bag for Pro Series # 63153 Cargo Carrier
- Q&A: Will Curt Cargo Bag Fit 22x60 Flint Hill Goods Cargo Carrier
- Q&A: Is There a Support Brace Designed for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Q&A: Will Roadmaster Spare Tire Carrier Allow Full Opening Of Rear Doors On 2026 Ram Promaster Van?
- Article: Best Hitch Cargo Carriers
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: My Trailer Hitch Doesn't Fit
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?