Is there a License Plate Frame for Snap-In License Plate, Utility or Dash Light # LP11CB
Updated 11/06/2017 | Published 11/04/2017
Products Featured in This Question
Question:
Obviously the frame needs to be metal for the grounding but is there a certain frame to use?
asked by: Mitch
0
Expert Reply:
Snap-In License Plate, Utility or Dash Light # LP11CB, when used as a license plate light, fits into a 1-1/4 inch hole in a bumper; usually found on trucks with step bumpers. There isn't a license plate frame that has a 1-1/4 inch hole. The hole would have to be put into the frame if used on a trailer.
Another option is to use a license plate frame with a built in light such as # LP55CB or # LPL55CB.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics Snap-In Mini License Plate Light - Incandescent - Round - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 1-1/2 Inch Diameter
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing Demco Channel Tongue Trailer Couplers # DM16080-95 & # DM15931-95
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: How to Install a Brake Controller in a 2014 Toyota Tundra
- Q&A: Why You Shouldn't Loop Your Inverter to Your Converter
- Q&A: Trailer Jack Replacement for Shelby 5862A
- Q&A: Can Truck with Firestone Ride Rite Air Bag Kit Installed be Lifted By Frame
- Q&A: Looking For Caliper To Replace Discontinued Tie Down Engineering 46802 Caliper
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Rust Prevention
- Article: What Do I Need To Tow A Trailer?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Tire Sizing
- Article: How to Determine Tire/Wheel Diameter