Is Trimming Needed to Install Curt Trailer Hitch # 13445 on a 2007 Toyota 4Runner

Updated 06/01/2011 | Published 05/30/2011

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(90)

$274.74

1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs

(2639)

$13.28

Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs

(3984)

$29.11

Mounting Bracket and Installation Hardware - Pollak 7-Pole, RV-Style Trailer Connector - Vehicle End

(1247)

$4.17

Question:

I have a 2007 4 runner that currently has no hitch. Does installation involve cutting trim and does it just fit over spare tire? Thanks

asked by: Tim

Expert Reply:

According to the Installation instructions for Curt Trailer Hitch, # 13445, there is no trimming involved and the hitch fits around the spare tire. The only note is if the vehicle has a factory installed 7-Way trailer connector, it will need to be relocated using a mounting bracket like # PK12711U.

If you plan on doing some towing, the recommended ball mount is # D-4 and you can use pin and clip # PC3. For a ball, you can use # 19260 (1-7/8 inch diameter), # 19247 (2 inch diameter), or # 63847 (2-5/16 inch diameter). For trailer wiring, use Upgraded Circuit Protected Taillight Converter, # 119178KIT. I have included a link to the installation instructions for the hitch and a video showing a typical installation of the wiring harness.

expert reply by: Michael H