Replacing Trailer Taillight Lens Marked SAE AP2 04 DOT

Question

Question:

This is rectangular - 2inch x 2-3/4inch from a utility trailer. Optronics SAE AP2 04 DOT 1/4inch high with 2 screw holes along the 2inch side. Do you sell something like that?

asked by: Rjet

0

Expert Reply:

The SAE number is not normally a reliable way to find replacement lenses, but from previous customers who have had that same number and sent in pictures we were able to determine that the correct replacement lens is the # A39RB for the main lens and # A37RB for the side marker.

If what you have looks different send me a picture and I'll see what we have.

expert reply by: Jameson C

0

Answer 1

So SAE numbers aren't part numbers so it's hard to pick out replacement lights based on of them since that's not info that's stored as a cross reference. We've had customers with a similar number SAE-AP2-79 which turned out to be…

view full answer...

Answer 2

We have just what you need. Thanks for sending in the picture as that made it very easy. You are in need of the part #A2RB.

view full answer...

Answer 3

For the SAE AP2 99 DOT lens we know that the part #A2RB is the correct replacement.

view full answer...

Answer 4

The SAE number is not a reliable way to find a replacement light for the trailer. From our experience the replacement light is Optronics tail light part #ST36RB for the passenger side or part #ST37RB for the driver's side. These lights measure…

view full answer...

Answer 5

We have exactly what you need. For the amber lens light you would want the Oval Clearance Light part #MC38AB and then for the red light you would want the Peterson Red Oblong Clearance Light part #423000.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacing Trailer Taillight Lens Marked SAE AP2 04 DOT

Continue Researching