How Do Clear Utility Light # 507-12 Wire to Vehicle
Updated 09/16/2017 | Published 09/15/2017
Products Featured in This Question
Question:
My girlfriend recently got a used Jeep Wrangler and it has these lights on an aftermarket bumper and it appears theyve never been wired they just sit there with the one wire running out the back of the light. I was hoping someone could point me in the direction to get instructions to install this light properly. Is it too bright for her to use with her highbeams? If so where can I buy the switch because its not with the jeep thank you in Advance
asked by: Ryan P
Expert Reply:
You'll need to first find the power and ground wire and then wire them to your battery through a switch as needed.
If the lights are the part # 507-12 that you referenced then this grounds through the mounting hardware so all you need is to run a power wire to the single wire through a switch like # D16740. You'd want some 12 gauge wire like part # 12-1-1 (sold by the foot), for the wiring.
Product Page this Question was Asked From
Peterson PAR 36 Work Light w/ Mounting Bracket - Trapezoid Beam - Rubber Housing - Clear Lens
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Round
- Pedestal Mount
- Trapezoid Beam
- Incandescent Light
- White
- Peterson
more information >
Continue Researching
- Shop: Peterson Clearance and Side Marker Trailer Light - Waterproof - Incandescent - Red Lens
- Shop: Peterson Clearance and Side Marker Light - Submersible - Incandescent - Rectangle - Amber Lens
- Article: Trailer Lighting Requirements
- Search Results: spring latch
- Shop: Bolt-On Zinc Spring Latch
- Shop: RV Interior Lighting
- Q&A: Can The Bulb In A Peterson 421KRUS Tail Light Be Replaced
- Q&A: Horse Trailer Rear Door Hinge and Spring Latch Availability
- Q&A: Pin Length When Latched for the Bolt-On Stainless Steel Spring Latch # SL716SS
- Q&A: Replacement Options for a Sealed Trailer Light with a Bad Bulb
- Q&A: What is the Height of the Bolt-On Stainless Steel Spring Latch
- Q&A: Are Two Wires Required to Install the Clear Utility Light # 507-12 on a Trailer
- Shop: Peterson PAR 36 Work Light w/ Mounting Bracket - Trapezoid Beam - Rubber Housing - Clear Lens
- Shop: Bolt-On Stainless Steel Spring Latch
- Search Results: peterson 154
- Search Results: anchor
- Search Results: butt splice
- Search Results: mcl45ab
- Shop: Peterson Thin Line Clearance or Side Marker Trailer Light - Incandescent - Oval - Red Lens
- Shop: 3-Light Truck and Trailer Identification Light Bar with White Base - Red
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: How to Measure for Trailer Hitch Drop
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
on Off Road Lights
