What is the Height of the Bolt-On Stainless Steel Spring Latch

Question

Question:

when this latch is fastened down what is the height measurement ? Thanks

asked by: Jim

0

Expert Reply:

I went and measured a Bolt-On Stainless Steel Spring Latch # SL716SS and found that the height of it would be 15/16 of an inch. Check out the picture I attached that shows this measurement.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Peterson Trailer Tail Light #421KRUS is a sealed waterproof unit, but the bulb will technically replaceable. However, removing the cover to gain access to the bulb will damage this seal and the light will no longer be waterproof, so I do advise…

view full answer...

Answer 2

No, there should only be one wire coming out of the Clear Utility Light, item #507-12. There is another wire inside that light, see photo at right, that is attached to the mounting hardware for grounding the light. This requires that the light be…

view full answer...

Answer 3

The Peterson 440 series trailer lights typically have 4 screws at each of the corners of the lens that allow you to remove the lens and replace the bulb. It may be possible that you have a sealed version of these lights, in which case the bulb is…

view full answer...

Answer 4

I went and pulled a Bolt-On Stainless Steel Spring Latch #SL716SS from our warehouse and measure the dimension you are looking for and found it to be 1-7/8 inches. See the pic I attached, I added the dimension to the picture you submitted

view full answer...

Answer 5

You'll need to first find the power and ground wire and then wire them to your battery through a switch as needed. If the lights are the part #507-12 that you referenced then this grounds through the mounting hardware so all you need is to run a…

view full answer...

Answer 6

Thanks for the pictures of your horse trailer's rear door. The part #2212 will work as a replacement for the hinges that you have. We have spring latches too like the part #SL716SS as well but do not have door seals.

view full answer...

Answer 7

We actually have a handy help article, linked to the right for you, that explains this and other helpful information on trailer lights. Below is an excerpt: The light beam emitted from a P2 or P3 light spreads out 45 degrees to each side of its…

view full answer...

Answer 8

We have the perfect solution for you. I'd recommend going with two of the Buyers Products low profile LED floodlights, part #3371492135. The lamp is pretty small, so if you have some room between the top of the rear door and the roof you could…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

What is the Height of the Bolt-On Stainless Steel Spring Latch

Product Page this Question was Asked From

Continue Researching