Replacement Swivel Jack for Shelby Model 5764A With 5.5 Inch by 3 Inch Bolt Battern  

Based on my research, the Fulton Round, Snap-Ring Swivel Marine Jack #FTJ120W0301 will be a perfect replacement for your Shelby 5756A trailer jack. This jack will allow you to use the existing snap ring jack mount on your trailer for installation.…

I was not able to find any information on the capacity or mounting bracket dimensions of the Shelby 5776A. We do carry the Fulton Round, Snap Ring Marine Jack #FTJ120W0301 which is a replacement for the Shelby 5756 boat trailer jack but I was not…

The Shelby #5776 is the direct replacement for the #5756, but we do not offer that particular jack. The Fulton #FTJ120W0301 that you referenced would make an acceptable replacement. The capacity and the amount of lift or travel is identical. Both…

According to our research the Fulton Round, Snap-Ring Swivel Marine Jack #FTJ120W0301 will fit as a replacement for your Shelby 5756 boat trailer jack. It will allow you to keep the same bracket that is currently welded-on. You basically need to open…

In order to replace the Shelby Trailer Jack Model 5756 you have on your trailer now, I recommend taking a look at the Round Swivel Marine Jack w/ Wheel part #MJ-1206B. This jack bolts onto a trailer frame up to 4" tall and will not require any…

I would need to know specifically what model Fulton jack you have. It is possible that you may need #F500286 or another similar part but I can only determine the correct part, if available, with the jack model. There are several Fulton swivel jacks…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…