Direction of Equalizer # TREQ105 When Installed on Triple Axle Trailer
Updated 05/08/2020 | Published 07/19/2017 >
Question:
I am replacing my shackles and shims in my trailer Looking at your diagram on a triple axle set up Mine has the equalizer treq105 on the front tire to the middle tire then the treq1 from middle to back tire I see you are just opposite Would that make any difference? Also which way should the shackle be spring hanging down and going up to the equalizer? Right now I am having some binding when I try to move the axle up and down could you send pictures of which way the treq105 would be facing
asked by: Bill L
Expert Reply:
In the image with the suspension setup the equalizer # TREQ105 is placed between the front and second axles. Just like you have on your trailer. The front of the equalizer connects to the spring using a shackle strap and the rear is connected directly to the spring. As shown in the other image.
It's possible you have your shackle bolts too tight which can cause binding. The bolts should be torqued to yield meaning you want them tight but not so tight that the equalizers cannot move.
Product Page this Question was Asked From
Equalizer for 1-3/4" Wide Double-Eye Springs - 6-3/4" Long - 9/16" Center Hole
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 6-3/4 Inch Long
- Tandem Axle
- Triple Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: dexter equalizer
- Search Results: morryde u012 016
- Search Results: 2000 lbs trailer leaf springs
- Shop: etrailer Rust-Resistant 3-Leaf Double Eye Spring for 4K Trailer Axles - 25-1/4" Long - Dacromet
- Search Results: oval tail light
- Search Results: trailer lights
- Search Results: d ring
- Shop: Equalizer for 1-3/4" Wide Double-Eye Springs - 6-3/4" Long - 9/16" Center Hole
- Shop: TecNiq T14 Over 80" ID Bar and Load Lamp - Red/White Combo - Surface Mount
- Search Results: trailer axles
- Shop: Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole
- Video: Review of TecNiq Trailer Lights - Stop Tail Turn LED - TN92TR
- Shop: etrailer Rust-Resistant 4-Leaf Double Eye Spring for 3.5K Trailer Axles - 25-1/4" - Dacromet
- Shop: CE Smith U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts - Zinc
- Shop: etrailer Rust-Resistant 4-Leaf Double Eye Spring for 4K Trailer Axles - 26" Long - Dacromet
- Q&A: What Direction Should Wet Equalizer Bolts Face
- Video: Review of EMCO Trailer Leaf Springs - 3 Leaf Double Eye Spring 3500 lbs Trailer Axle - EM46AJ
- Video: All About the CE Smith U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles
- Video: Let’s Check Out the CE Smith U-Bolt Kit for Mounting Round Trailer Axles
- Video: Review of TecNiq Trailer Lights - Clearance Lights Red White Combo - TN82TR
- Q&A: Determining Hanger Spacing for Replacement Leaf Springs on Trailer
- Q&A: Replacement Equalizers and Shackle Straps for 2007 Keystone Raptor 3712
- Q&A: Solution for Needing 1,400 lb Trailer Leaf Spring Close to 22-1/4 inch
- Video: Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers Review
- Video: Complete Breakdown of the Optronics Fleet LED Trailer Tail Lights w/ Grommets
- Q&A: Will Triple Axle Hanger Kit # APTT5 Work with Leaf Springs E64SR
- Q&A: Replacement Idler Hub Options For A Dexter 8-135 Idler Hub
- Q&A: Will the Phoenix USA Rear Hub Cover Fit a 8 on 225mm Lug Pattern?
- Article: Where to Position the Trailer Axle?
- Article: 7 Common Questions Everyone Has About Trailer Tires





Toby S.
5/6/2020
Can this be used for front and rear equalizers...thus 4 for a triple axle? Is there a heavy hanger that will take the load?