Speed Rating for Kenda 5.70-8 Bias Trailer Tire with 8inch White Wheel

Question

Question:

What is the speed rating on these tires Kenda 5.70-8 Bias Trailer Tire with 8inch White Wheel - 4 on 4 - Load Range D - AM30153

asked by: Jeremy

1

Helpful Expert Reply:

The speed rating for the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel # AM30153 is 65 mph.

expert reply by: Jameson C

1

Answer 1

The highest rated 8 inch wheel/tire combo we offer would have an 'M' speed rating, which is good up to 81mph. This would be a 215/60-8 bias ply tire mounted on a 8 x 7 inch wheel with a 4 on 4 bolt pattern. The tire has a C load rating, with…

view full answer...

Answer 2

To find the correct hub for your boat trailer there are a couple things you need to know. First, you said the bearings you have are 07100. In my research I found that the 07100 bearing has an inner diameter of 1.000 inch. We have a bearing that…

view full answer...

Answer 3

As you mentioned in your question, upgrading to higher load range tires on your trailer is not going to increase the weight capacity of the trailer itself. However, a higher-rated tire will have the benefit of running a bit cooler when compared to…

view full answer...

Answer 4

Both the 4.80/4.00-8 and 5.70-8 tires sizes will fit the same wheel size, 8 x 3-3/4 inch. The 5.70 is taller by 2 inches and wider by 1.2 inches. If you have more than 1 inch of space between the tire and a fender and more than 1.2 inches between the…

view full answer...

Answer 5

For smaller tire sizes like the 4.80-8 that you mentioned the highest speed rating we have is 65 mph like the part #AM10002. This is in part due to the smaller diameter of the tire which means it will be spinning more revolutions at the same speed as…

view full answer...

Answer 6

Trailer rims/wheels can often accept more than one single tire size but this is not always the case, especially with the smaller wheel sizes like an 8-incher. Tire size 4.80/4.00-8 only fits on one specific rim size, one that is 3-3/4-inches wide and…

view full answer...

Answer 7

The main difference between a 5.70-8 trailer tire and a 215/60-8 will be the width. Your current tire is about 5.9 inches wide and the 215/60-8 is about 8.9 inches wide. They will both be about the same height. If your current wheel setup has more…

view full answer...

Answer 8

According to my research Victor 47376 grease seal has an inner diameter of 1.218 inches and an outer diameter of 1.983-inches. The seal we offer nearest to those dimensions is part #34823 as a single seal or part #RG06-010. These have matching outer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Speed Rating for Kenda 5.70-8 Bias Trailer Tire with 8inch White Wheel

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching