Brackets to Install Keel Rollers Above a Boat Trailers Frame
Updated 06/16/2017 | Published 06/15/2017
Products Featured in This Question
Question:
I am trying to add 10inch rollers to help center a 18foot boat when putting it back on a Yacht Club 1818B bunk trailer. The problem is that the cross members are too low to install the rollers . So, is there an aftermarket plate that can be used to raise the roller bracket or are we looking at fabricating a bracket?
asked by: Phil B
Expert Reply:
If I understand what you're trying to do I think we can help.
We have the Adjustable Mounting Brackets for Keel Rollers # CE32004G. They'll install onto your trailer's frame and will hold a keel roller that is the width of the frame plus 2 inches.
If you need a 10 roller # YR1000Y will work on the brackets using # CE10726A.
If I missed the mark and misunderstood you just let me know.
Product Page this Question was Asked From
CE Smith Adjustable Mounting Brackets for Keel Rollers - Galvanized Steel - 11-1/2" L - 1 Pair
- Boat Trailer Parts
- Rollers
- Roller Bracket
- 11-1/2 Inch Tall
- Galvanized Steel
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Ducted Furrion Chill Cube With Heat Pump Include Remote
- Q&A: Recommended Roller Bunks to Use on a Boat Lift
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Q&A: Difference Between Ark Ezi-Guides Self-Aligning Boat Trailer Loading Systems
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: Base Dimensions for Buyers Products Trailer Hand Winch
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure for Trailer Hitch Drop
- Article: Determining Trailer Tongue Weight
- Article: Trailer Lighting Requirements
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)