Distance from Ball to End of Chain Bracket on Curt Short Arm Weight Distribution System # C17333

Updated 06/12/2017 | Published 06/09/2017

Products Featured in This Question

Curt Short-Arm Weight Distribution System with Shank - Trunnion Bar - 15,000 lbs GTW, 1,500 lbs TW

(37)

$440.59

2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 12,000 lbs

(2639)

$23.44

2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000

(4008)

$19.11

Question:

what is the measurement from the center of the ball to the back side of the frame bracket on a short arm weight distribution system? I need less than 32 inches if possible.

asked by: LARRY T

Helpful Expert Reply:

On Curt weight distribution system # C17333 from the center of the ball cavity in the trailer coupler to the far edge of a chain hanging bracket it is 30-5/8 inches. It sounds like this will work out for you since you are looking for less than 32 inches.

The only other part needed is a properly sized ball. For a 2-5/16 inch ball use # 19286. For a 2 inch ball use # A-90.

expert reply by: Michael H