Wiring Adapter Compatible With 2012 Ford F53 Chassis And Prodigy P2 Brake Controller

Question

Question:

product 90885-3035-P Just wanted to verify that this part includes the adapter wire/harness to plug into 2012 F53 Ford chassis.

asked by: Mike Y

0

Expert Reply:

The Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional # 90885 is confirmed to fit your 2012 Ford F53 Chassis using the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3035-P. This harness will connect to factory wiring normally located beneath the dash near the center console or underneath and to the left of the steering column.

expert reply by: Jason S

0

Answer 1

There is no specific harness for you 2012 F53 that works with the Brake Buddy Stealth Supplemental Braking System - Proportional Item #HM39530 however, the 2012 F53 does have a brake controller plug under the dash somewhere around the steering…

view full answer...

Answer 2

The brake controller connector is located on the left side of the steering column support, as shown in the provided photo. You'll need the #3034-P brake controller wiring harness. For a brake controller I would recommend the Prodigy P2 Brake…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 6

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Wiring Adapter Compatible With 2012 Ford F53 Chassis And Prodigy P2 Brake Controller

Featured Help Information

Miscellaneous Media

Continue Researching