Replacement Trailer Coupler for 2 inch Hitch Ball
Updated 05/16/2017 | Published 05/15/2017
Question:
Replacing a 1 7/8inch coupler on a 1992 Shorelander trailer due to it being bent. Want to replace with 2inch but cant fine one with the mounting holes to where I dont have a gap between coupler and top of toungue. Any suggestions? Picked up a Reece one and it is at least 3/8inch gap.
asked by: Sean
Expert Reply:
It would depend on the measurements of your trailer's tongue to find an exact fit. One of our most popular couplers, # CT-3001-Z, is 10-3/4 inches long by 3-1/2 inches wide and is for 2 inch trailer tongues.
The mounting holes are 1/2 inch diameter holes spaced 3-1/16 inches apart on center.
Product Page this Question was Asked From
Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 3500 lbs GTW
- 2 Inch Channel
- Trigger Latch
- 2-Bolt
- Marine Grade
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Air Lift 1000 for 2025 GMC Acadia Fit 2025 Chevy Traverse
- Q&A: How Much Does the Gen-Y Serrated Hitch Mounted Step Weigh and is it 100% Steel?
- Q&A: Replacement Coupler for a CE Smith Multi Sport Boat and Kayak Trailer
- Q&A: What is the Usable Length Needed for a Pin on a Curt QuickPin No-Latch Trailer Coupler?
- Q&A: Replacement Bearings For A 6,000 Pound Dexter Axle
- Q&A: Can I Change My Trailer Coupler from a 1-7/8 Inch Coupler to a 2 Inch Coupler
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Availability Of Trailer Hitch For 2025 BMW i5 M60
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class