Can Putty Tape be Used When Installing Plunger and Rubber Socket Door Holder
Updated 05/09/2017 | Published 05/07/2017
Question:
Hi, the male and female sides dont have gaskets between the part and trailer except for the rubber female side. Should I use putty tape on these? I have a vintage trailer and everything attached to it seems to have the putty tape!
asked by: Terry H
0
Expert Reply:
You can use putty tape or any gasket material to mount the female side of the Plunger and Socket Door Holder # PLR64-66.
This assembly makes it easier to hold a trailer door open when needed.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 2-1/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- Straight
- 2-1/4 Inch Long
- 2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What is The Proper Way To Measure A Trailer Fender?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Q&A: When do You Need a Breakaway Battery Charger and How Does it Function
- Q&A: What Inner Tube do You Have for My Bulldog Gooseneck Coupler that Doesn't Use Load-Bearing Pin?
- Q&A: Replacement Inner Tube For Gooseneck Trailer Coupler That Doesnt Use Through Pin
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Replace an RV Roof Vent Cover
- Article: Roof Rack Information